This research – funded by the iMOVE Cooperative Research Centre, University of Melbourne, the Department of Infrastructure, Transport, Regional Development and Communications, and ITS Australia with support from IAG, Intelematics and Transmax – has the potential to dramatically reduce trauma and the road toll.
The eight-month project involved a comprehensive analysis of Victorian traffic accident data from 2006-2019 and state-of-the-art traffic micro-simulation studies from within the Australian Integrated Multimodal Ecosystem (AIMES).
Researchers focused on understanding cooperative intelligent transport system (C-ITS) technologies that would help drivers in eight main ways including; lane guidance, curve speed, collision avoidance, do not pass and blind spot warnings, intersection movement and right turn assistance, plus pedestrian safety messages.
Professor Majid Sarvi, Lead of Transport Technologies at the University of Melbourne said: “Our analysis of Victorian Road Safety data shows that with eight significant connected safety focuses, we have the ability to reduce the incidence of crashes by up to 78% and make vehicle transport safer for all road users.”
Professor Sarvi’s team of researchers including Dr Neema Nassir and Dr Patricia Sauri Lavieri found that curve speed warnings could have the most significant impact in rural areas.
52% of all fatal accidents occurred in rural Victoria, compared to 37% of all fatal crashes occurring in urban areas of Melbourne.
Motorcyclists stand to derive the most benefit from curve warnings, as curve speed was a factor in 17% of crashes involving motorbikes, data shows.
C-ITS vehicle adaptations include cameras, ultrasonic or wireless sensors, antennas, 3D HD mapping capabilities, GPS, and Lidar which is a light pulsing laser device to accurately measure distances.
Professor Sarvi suggested that some technologies would become standard in new cars off the production line, while older vehicles could be retrofitted with aftermarket hardware.
Older vehicles involved in fatal crashes four times more frequently than newer cars
Data from ANCAP included as part of the overall study shows the oldest vehicles (built in 2001 or earlier) on Australian roads accounted for just 20% of the total national vehicle fleet but were over-represented in fatal crash data.
“1 in 5 cars on Victorian roads are considered older, but they are involved in 36% of all fatal crashes. By contrast, newer vehicles [built between 2012-2017] make up 31% of road vehicles but are involved in just 12% of fatal crashes,” Professor Sarvi said.
The rate of fatal crashes per registered vehicle for oldest vehicles was four times higher than that of newer vehicles.
Improving Melbourne’s CBD traffic congestion with connected vehicles
Traffic micro-simulation experiments were conducted in Melbourne’s arterial corridors within AIMES. Researchers concluded that if just 30% of all vehicles on the roads during peak hour were connected vehicles, traffic congestion could be driven down by up to 11%.
A separate network micro-simulation in Melbourne’s CBD during peak hour (pre-COVID-19) found that average travel speeds could improve by up to 10% if a fifth of cars were connected vehicles.
What works for Victoria works for Australia
While this study honed in on 15 years’ worth of Victorian crash data, the findings are broadly applicable to other jurisdictions across the country where similar C-ITS uptake has the potential to reduce crashes, save lives and improve travel times.
Industry stakeholders red flag driver fatigue and rail crossings
Professor Sarvi’s research team’s interviews with industry stakeholders revealed common challenges across the transport sector. These include driver fatigue for fleet operations, rail crossing safety, cross traffic, overhead bridge heights and extreme weather events.
Stakeholders broadly agreed that significant standardisation and regulation is needed, along with a unified national approach toward C-ITS communications adoption.
It is estimated to take anywhere from a few years to a few decades for safety enhancing technologies to be commonplace in vehicles, hinging on broad support from government and car manufacturers.
As stated by iMOVE:
iMove Managing Director Ian Christensen said: “C-ITS is a technology whose time has arrived, and based on research not only by our research partners in Australia but all around the world we know lives will be saved if this technology is implemented widely.
“Making the adoption of C-ITS a national priority will bring major social and economic benefits, and lead to greater transport efficiency and, most importantly, increased safety.”
As stated by ITS Australia:
ITS Australia CEO Susan Harris said, “This research shows the vital importance of transport technologies in both reducing road trauma and improving our transport networks.
“Supporting the deployment of these road safety and efficiency technologies is a key issue for ITS Australia and our members.”
Read the research white paper and supporting research documentation here
